Using the Universal Remote Control
1. Select the mode (TV, PVR, DVD, AUDIO) you want to set by pressing the corresponding button on the remote control. The button will blink once.
2. Keep pressing the button for 3 seconds until the button lights on.
3. Enter the 4-digit code. Every time a number is entered, the button will blink. When the fourth digit is entered, the button will blink twice.
4. If a valid 4-digit code is entered, the product will power off.
5. Press the OK button and the mode button will blink three times. The setup is complete.
6. If the product does not power off, repeat the instruction from 3 to 5.
Note:
• When no code is entered for one minute the universal setting mode will switch to normal mode.
• Try several setting codes and select the code that has the most functions.
Panasonic TVs
There seems to be a problem with Panasonic TVs when using the remote for the Humax FOXSAT-HDR, this is due to Panasonic TVs requiring a longer signal than that given out by the receiver’s remote.
Try code 0650 first, input the code as instructed in the manual and then selected OK – holding down the standby button on the Humax controller then turns the TV off. Try all the codes and see which gives the most control functions.
